The ropes produced by the rope-tying machine are indispensable in people's lives. How do we operate the rope-making machine as a production line? How to operate the rope to reduce the failure?
The first step is to start the motor and see if the direction of operation is the same as the direction of the indication. If it is not the same, the power should be turned off and the two wires of the capacitor and the motor should be swapped, so that the direction can be consistent with the indication.
The second step, artificially pushing the flip, when the rope spins out of 1 meter, the rope is wound through the spacer ring on the thin end of the wood plate, and then the power supply can be switched on.
The third step, the amount of feed in the production should not be too much, uniform feed is appropriate. Feeding grass can not be interrupted.
In the fourth step, when the rope is full, turn off the power of the rope making machine. Cut the rope near the wooden plate. Remove the wooden plate and remove the straw rope. After the rope plate is installed, wind the original rope. Reproduction on wooden tray.
This operation of the rope making machine not only improves the efficiency, but also reduces the occurrence of failures and accidents.
As a device that is currently very important in the plastics industry, the rope hitting machine has always been a key point in terms of technology. However, maintenance and repair cannot be neglected. The main reason for everyone to work hard in this area is to The reason is that once a failure occurs, it will be huge in terms of maintenance and costs.
Therefore, we should pay attention to the lubrication of various parts of the rope-tying machine in normal use, and maintain the premise of normal operation, and the periodic lubrication is also an important aspect to reduce the wear of the wire-drawing machine. Secondly, for spare parts that are frequently replaced, we must make more preparations so that we do not need it when it is needed. Again, it is during the operation that skilled workers must be employed, and novices must use skilled workers to guide them.
