The whole system of the flat wire drawing machine is more complicated. The control equipment requires coordination and cooperation among the various motors. At the same time, to achieve this goal, four servo motor controls are used so that the data can be fully satisfied in real time. Interaction. Therefore, in order to ensure the location of the track sideline according to the algorithm, the line of wire can be required to be quickly calculated, which requires full use of the servo internal firmware function.
In this way, from the calculation of the drive itself, the total time of calculating the line position of the traditional flat wire drawing machine control system is greatly omitted, and at the same time, instructions can be sent to the drive to ensure the line, thus greatly reducing the Delay through the controller.
Flat wire drawing machine produces uniform thickness, smooth, not easy to break wire, high working efficiency and low energy consumption. It is one of the important equipments that are worth recommending. The characteristics of the flat wire drawing machine include the structure of independent air duct design, the fan can be disassembled freely, and the heat dissipation is good. But the safe operation of the flat wire drawing machine should be paid attention to.
The flat wire drawing machine is properly equipped with a brushed belt. Carefully check the lubrication of the upper and lower bearing seats and the lifting screw, and confirm that the machine can be switched on when there is no person on the discharge side. The pressure adjustment should be moderate and it is forbidden to exceed the red line so as to avoid causing equipment or personal accidents.
