Today, we come and a round wire drawing machine manufacturer to come and understand what should be done from the constant and test wire drawing machine.
Drawing machine can adapt to different process requirements, with a large range of traction speed regulation, traction can be stepless speed regulation, winding speed and traction speed remain constant. Drawing machine drawing range can also be changed accordingly, depending on the spinneret changes.
The drawing machine coiling device is driven by a torque motor and maintains a constant linear velocity with the drafting device. The winding machine can be provided with a plurality of reels. The rewinding and rotation of the reeling can be switched by the handle so that the reeling needs to be changed. Cooling device uses water, the height of the water tank can be increased or decreased according to process requirements. Cooling water surface. The height can be controlled by the inlet and outlet valves, and the stretching slot of the drawing machine is electrically heated to meet the process requirements.
1.The heating system should heat the barrel to process temperature in 2H.
2.The temperature of the oil in the gearbox does not exceed 35 degrees Celsius. The temperature rise of oil in other 3.gearboxes does not exceed the requirements of the relevant standards.
Electrical safety requirements should be met to ensure operator and production safety.
In order to ensure that the wire drawing machine can guarantee reliable, stable and correct operation, it must be debugged after it is installed and before it is used. When debugging, it can't be sloppy. If it is in error, it will have a far-reaching impact. So what should you pay attention to?
Debugging drawing machine must first ensure the correct wiring, mainly refers to the signal line between the servo drive and the controller, otherwise the drawing machine servo will not work properly; but the single can be normal operation is not enough, but also need to make reasonable mode The setting, after all, each application of the device has different requirements, so that all aspects are matched is critical
The second reason is that the motor must have good grounding. On the one hand it is to avoid interference, and on the other hand it is to avoid leakage. Speaking of interference, we still have to say one more thing. Then, don't tie the encoder cable and signal cable together with the motor cable and power cable or through a slot, and try to maintain a certain distance. interference
